Today's Message Index:
----------------------
1. 06:29 PM - Elevator Horn Weldment - Installation (Garey Wittich)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Elevator Horn Weldment - Installation |
Greetings:
Ref - RV-8A:
When trying to attach the Elev Horn Weldment to the Elev Spar and Root Rib, the
Weldment did NOT lay flat against the Spar and Root Rib simultaneously. Measured
the Weldment's angle of 68 degrees. The angle formed by the Spar and Root
Rib is 70 degrees. Inorder to get the Weldment angle to spread from 68 degrees
to 70 degrees, MUCH force is needed. This does not seem right as too much
stress would be applied to the Spar / Root Rib / Weldemnt combination.
Both Left and Right Weldments measure 68 degrees. (I have an OLDER Kit, so maybe
this could be the problem where the NEWER Kit is 70 degrees.)
Has anybody else experienced this and how did you handle it ??
Appreciate your help !!!!
Garey Wittich Santa Monica, CA (310) 392-1682
Garey
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|