---------------------------------------------------------- RV8-List Digest Archive --- Total Messages Posted Tue 08/25/09: 5 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:46 AM - Re: RV8- WTB Transponder (japhillipsga@aol.com) 2. 06:46 AM - Re: RV8 Install MGL Odyssey (japhillipsga@aol.com) 3. 06:48 AM - Re: RV8- Trio AP Install (japhillipsga@aol.com) 4. 09:52 AM - Re: Oil Cooler Size On RV-10...? (Richard Martin) 5. 10:04 AM - Re: Oil Cooler Size On RV-10...? (Matt Dralle) ________________________________ Message 1 _____________________________________ Time: 06:46:37 AM PST US Subject: RV8-List: Re: RV8- WTB Transponder From: japhillipsga@aol.com Hello Fellow RV Obsessed Folks, I need a Garmin 327 or 330 Transponder with tray. Please write or call my cell, 478-731-9678, Thanks, Bill of Georgia -----Original Message----- From: RV8-List Digest Server Sent: Tue, Aug 25, 2009 2:58 am Subject: RV8-List Digest: 0 Msgs - 08/24/09 * ================================================= Online Versions of Today's List Digest Archive ================================================= Today's complete RV8-List Digest can also be found in either of the two Web Links listed below. The .html file includes the Digest formatted in HTML for viewing with a web browser and features Hyperlinked Indexes and Message Navigation. The .txt file includes the plain ASCII version of the RV8-List Digest and can be viewed with a generic text editor such as Notepad or with a web browser. HTML Version: http://www.matronics.com/digest/digestview.php?Style=82701&View=html&Chapter 09-08-24&Archive=RV8 Text Version: http://www.matronics.com/digest/digestview.php?Style=82701&View=txt&Chapter 09-08-24&Archive=RV8 =============================================== EMail Version of Today's List Digest Archive =============================================== ---------------------------------------------------------- RV8-List Digest Archive --- Total Messages Posted Mon 08/24/09: 0 ---------------------------------------------------------- Today's Message Index: ---------------------- -Matt Dralle, List Admin. ________________________________ Message 2 _____________________________________ Time: 06:46:57 AM PST US Subject: RV8-List: Re: RV8 Install MGL Odyssey From: japhillipsga@aol.com Dear RV-8/a Builder Fellows, I need some first hand installer info on the Odyssey EFIS from MGL into the RV-8. Got photos of where all the pieces are best located? Need some help here. Best regards, Bill of Georgia?? -----Original Message----- From: RV8-List Digest Server Sent: Tue, Aug 25, 2009 2:58 am Subject: RV8-List Digest: 0 Msgs - 08/24/09 * ================================================= Online Versions of Today's List Digest Archive ================================================= Today's complete RV8-List Digest can also be found in either of the two Web Links listed below. The .html file includes the Digest formatted in HTML for viewing with a web browser and features Hyperlinked Indexes and Message Navigation. The .txt file includes the plain ASCII version of the RV8-List Digest and can be viewed with a generic text editor such as Notepad or with a web browser. HTML Version: http://www.matronics.com/digest/digestview.php?Style=82701&View=html&Chapter 09-08-24&Archive=RV8 Text Version: http://www.matronics.com/digest/digestview.php?Style=82701&View=txt&Chapter 09-08-24&Archive=RV8 =============================================== EMail Version of Today's List Digest Archive =============================================== ---------------------------------------------------------- RV8-List Digest Archive --- Total Messages Posted Mon 08/24/09: 0 ---------------------------------------------------------- Today's Message Index: ---------------------- -Matt Dralle, List Admin. ________________________________ Message 3 _____________________________________ Time: 06:48:01 AM PST US Subject: RV8-List: Re: RV8- Trio AP Install From: japhillipsga@aol.com Dear Fellow RV-8 Builders Fellows, I've received my Trio Gold AP servos for my RV-8a.? Beautiful things they are.? Who has installed them in their RV-8? The wing aileron unit is pretty straight forward so no problem. On the other hand the elevator servo placement is less defined. Anybody got photos and thickness of brackets, location, length of push rod,etc? Hope to hear from someone and best regards, Bill of Georgia? -----Original Message----- From: RV8-List Digest Server Sent: Tue, Aug 25, 2009 2:58 am Subject: RV8-List Digest: 0 Msgs - 08/24/09 * ================================================= Online Versions of Today's List Digest Archive ================================================= Today's complete RV8-List Digest can also be found in either of the two Web Links listed below. The .html file includes the Digest formatted in HTML for viewing with a web browser and features Hyperlinked Indexes and Message Navigation. The .txt file includes the plain ASCII version of the RV8-List Digest and can be viewed with a generic text editor such as Notepad or with a web browser. HTML Version: http://www.matronics.com/digest/digestview.php?Style=82701&View=html&Chapter 09-08-24&Archive=RV8 Text Version: http://www.matronics.com/digest/digestview.php?Style=82701&View=txt&Chapter 09-08-24&Archive=RV8 =============================================== EMail Version of Today's List Digest Archive =============================================== ---------------------------------------------------------- RV8-List Digest Archive --- Total Messages Posted Mon 08/24/09: 0 ---------------------------------------------------------- Today's Message Index: ---------------------- -Matt Dralle, List Admin. ________________________________ Message 4 _____________________________________ Time: 09:52:15 AM PST US From: "Richard Martin" Subject: Re: RV8-List: Oil Cooler Size On RV-10...? When I built my RV8, I attempted to use the SW cooler recommended by vans, however it was inadequate. Upon advice of Monty Barrette, and Dave Anders (still the fastest RV) I obtained a Niagara/Harrison 10 cooler and mounted it on the rear baffle behind cyl 4 and tilted it down approximately 35 degrees (tilt as much as possible without contacting engine mount) (it will be necessary to remove some metal from the flange on the cooler to prevent contact with engine mount tube). This set up has proven to be excellent providing good cooling in all temperatures up to 95 degrees outside air including the Air Venture races when I run at 100 percent of power at low altitude for over 2 hours (2700 rpm, 27-29 inch manifold pressure) average indicated airspeeds are 220-235mph depending on OAT. ----- Original Message ----- From: "Matt Dralle" Sent: Wednesday, August 19, 2009 10:08 PM Subject: RV8-List: Oil Cooler Size On RV-10...? > > > Hey, what size oil cooler to the RV-10's use? Is it the same on on > the -7's and -8's? "Oil Cooler II". Or, do they use a larger one? > > I've got a SW10610R for my IO-390 on the RV-8 which is a monster sized > cooler. The stock "FF-709" mounting bracket is way too small. Does Van's > have a larger one available? What's used on the RV-10? > > I guess that I could make one, but I'd rather Van's CNC punch did, if you > know what I mean...? > > Thanks! > > Matt Dralle > RV-8 #82880 N998RV > http://www.mykitlog.com/dralle > FWF > > > ________________________________ Message 5 _____________________________________ Time: 10:04:42 AM PST US From: Matt Dralle Subject: RV8-List: Re: Oil Cooler Size On RV-10...? Thanks for the feedback Richard. Do you have some pictures of your installation you could post to the Lists? BTW, your computer clock is 5 days behind. Matt Dralle RV-8 #82880 N998RV http://www.mykitlog.com/dralle FWF At 08:33 AM 8/20/2009 Thursday, you wrote: >--> RV-List message posted by: "Richard Martin" > >When I built my RV8, I attempted to use the SW cooler recommended by vans, however it was inadequate. Upon advice of Monty Barrette, and Dave Anders (still the fastest RV) I obtained a Niagara/Harrison 10 cooler and mounted it on the rear baffle behind cyl 4 and tilted it down approximately 35 degrees (tilt as much as possible without contacting engine mount) (it will be necessary to remove some metal from the flange on the cooler to prevent contact with engine mount tube). This set up has proven to be excellent providing good cooling in all temperatures up to 95 degrees outside air including the Air Venture races when I run at 100 percent of power at low altitude for over 2 hours (2700 rpm, 27-29 inch manifold pressure) average indicated airspeeds are 220-235mph depending on OAT. >----- Original Message ----- From: "Matt Dralle" >To: ; ; >Sent: Wednesday, August 19, 2009 10:08 PM >Subject: RV8-List: Oil Cooler Size On RV-10...? > > >> >> >>Hey, what size oil cooler to the RV-10's use? Is it the same on on the -7's and -8's? "Oil Cooler II". Or, do they use a larger one? >> >>I've got a SW10610R for my IO-390 on the RV-8 which is a monster sized cooler. The stock "FF-709" mounting bracket is way too small. Does Van's have a larger one available? What's used on the RV-10? >> >>I guess that I could make one, but I'd rather Van's CNC punch did, if you know what I mean...? >> >>Thanks! >> >>Matt Dralle >>RV-8 #82880 N998RV >>http://www.mykitlog.com/dralle >>FWF ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rv8-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV8-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rv8-list Browse Digests http://www.matronics.com/digest/rv8-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.