Today's Message Index:
----------------------
1. 09:56 AM - Elevator Trim Motor Wiring Routing (Stan Loer)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Elevator Trim Motor Wiring Routing |
Should have addressed this sooner. The leading edge is rolled and
riveted, and I now realize that the existing hole through the spar won't
work. I think this has been a past subject on the list, but didn't pay
attention at the time. Difficult, but probably not impossible to drill
a new routing hole inboard. Would have to open up the leading edge for
access. Plan B might be to drill a hole through the butt rib concentric
with the forward lightening hole in the horn bracket. Recommendations
greatly appreciated.
Stan Loer
stazel@cpros.com
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|