Today's Message Index:
----------------------
1. 03:39 PM - Finishing Empennage Tips (Stan Loer)
2. 08:10 PM - RV-8 Part # F-601Y (Matt Dralle)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Finishing Empennage Tips |
While I've decided to rivet the stabilizer and elevator tips per plans,
I'm still debating other finishing issues. I've seen tip sections
totally glassed in, filling in the inboard end of the elevator tip and
adjacent end of the stabilizer, and basically making all joints
disappear from the rivet line out. Looks great, but I'm not sure what I
would be in for if I decided to go that way. Would like some feedback
from other builders. Pros/cons and, from those who have gone there, a
bit on preferred materials and processes and maybe some photos. Not
asking for much. I've picked up a lot of good ideas from list comments
and direct contact. Guess I still have a long way to go.
Stan Loer
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RV-8 Part # F-601Y |
Dear Listers,
On Drawing 60 of the RV-8 plans, there is a part called out numbered "F-601Y" which
appears to be an angle of some sort about 2" long. It seems to be used to
hold the hinge pins for the rear, upper cowling. Other than a reference to
it on Drawing 60 where its simply shown as a dotted drawing for positional reference,
I can't seem to find where it is shown in 3D for fabrication nor can I
find it among my pre-punched bits and pieces.
Am I just not seeing the 3D drawing for some reason??
Thanks!
Matt Dralle
RV-8 #82880 N998RV
http://www.mykitlog.com/dralle
Cowling's Almost Done!
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|