Today's Message Index:
----------------------
1. 02:56 PM - Gear Tower Covers ()
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Gear Tower Covers |
I=99ve cut out each gear tower lower web in my QB fuselage and
plan to install 0.063 thick covers, but a bit different from what I have
seen. I am curious as to whether anyone else has done this and/or if
I=99m missing something which would make this a bad idea. My
covers will have cutouts matching the lower half of the middle hole and
upper half of the lower hole. Essentially a very exaggerated
=9CH=9D. The overall dimensions are
4.13=9Dx7=9D. Each plate will install with 16 #8 machine
screws, probably AN525=99s, and AN365 nuts. The primary advantage
I see is that this eliminates all the nutplates required with full
covers. Also, the holes will be preserved for inspection purposes and
in the unlikely event that any maintenance or servicing at all can be
done through them. All feedback greatly appreciated.
Stan Loer
RV-8 QB
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|