Today's Message Index:
----------------------
1. 11:53 AM - ADS-B In Plus ()
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Next question. I am looking at potential ADSB-In antenna locations. My
comm. antenna will be just aft of the front spar on the left side with
the X-ponder antenna just forward of the F-807 bulkhead and between the
right F-813 and 814 seat ribs. Just makes the recommended 36 in.
separation. For the ADSB-in, I am seriously looking at the left side
forward of the F-808 bulkhead and outboard of the F-818 baggage rib with
minimum 24 in. separation from the X-ponder antenna. I think
there=99s adequate ground clearance at that location. With a
forward battery, I could make a bracket for the Dynon ADSB-470 receiver
to mount back there. Makes for a really short antenna cable run, but I
don=99t know for sure if proximity to the A/P pitch servo creates
any issues. So, good choice or better options? I also welcome any and
all recommendations on routing antenna cables. I am trying to absorb
everything I can get about avoiding RFI and any other kinds of I that
might cause problems. Gives me a headache.
Stan Loer
RV8 QB
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|