Today's Message Index:
----------------------
1. 03:47 PM - EGT (Roy Taylor)
2. 07:03 PM - Re: EGT (Ernest Kells)
Message 1
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: "Roy Taylor" <Royandjilly@btinternet.com>
Next, related query....What is likely to be the leanest cylinder to which I should
affix the adjacent (only) EGT.
Thanks, Roy, G-RUVY. ( just hung the engine on, 1 hour, no probs)
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: "Ernest Kells" <ernest.kells@sympatico.ca>
> > message posted by: "Roy Taylor" <Royandjilly@btinternet.com>
> Next, related query....What is likely to be the leanest cylinder to which
I should affix the adjacent (only) EGT.
> Thanks, Roy, G-RUVY
I used cylinder #4 for the following reasons;
- it is the rearmost cylinder - to the rear firewall.
- it is specified in the Vans EGT instructions
- it was personally recommended to me for my configuration by Scott at Vans
- although I cool oil off #4 cylinder I heat the cabin off #3 (would seem to
balance out).
BTW: if you're talking instruments & FWF stuff, are you getting "the itch"?
Ernest Kells - RV-9A O235-N2C, Wood Prop
90+% Complete - Fairings
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|