Today's Message Index:
----------------------
1. 03:11 PM - F7108 A/B F7108 A/B forward fuselage question (Richard Tasker)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | F7108 A/B F7108 A/B forward fuselage question |
--> RV9-List message posted by: Richard Tasker <retasker@optonline.net>
I am working on the upper forward fuselage (dwg 24) for my 9A with
sliding canopy. On the drawing it says to insert an AN960-6 washer
between F7108A and F7108B to allow space for the "hatchet" end of the
canopy support.
Well, first, there were no AN960-6 washers supplied with the fuselage
kit (as far as I can tell).
Second, I could steal one from those supplied with the finish kit, but
AN960-6 washers are only 0.031" thick anyway, so how does that provide
enough space for the canopy support end which is 0.075 thick?
What did you guys do who have already passed this point in construction?
I am sending this to the RV7 list as well since I believe the
construction is the same.
Dick Tasker, 90573
Fuselage, finish kit is here...
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|