Today's Message Index:
----------------------
1. 07:26 AM - Re: RV9-List Digest: 3 Msgs - 01/11/04 (david edgemon)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RV9-List Digest: 3 Msgs - 01/11/04 |
--> RV9-List message posted by: david edgemon <dedgemon@knology.net>
Steve,
I recently installed my exhaust on a O-320 D1A. I cut the stainless
tubes down from their delivered length (4.5 ?)
to about 3 incheds. This works well. I ended up with approx 1 inch of
tube in the rubber tubing on each leg.
The horizontal tube ran under the mixture and throttle cables just above
the nose gear leg.
Note: You should mount the cabin heat muff first since these exhaust
hangers will have to go around it. Ask
me how I know. :-)
Good Luck
>________________________________ Message 1 _____________________________________
>
>
>Time: 10:37:19 AM PST US
>From: "Steve Sampson" <SSampson.SLN21@london.edu>
>Subject: RV9-List: exhaust
>
>--> RV9-List message posted by: "Steve Sampson" <SSampson.SLN21@london.edu>
>
>I seem tp be getting in a tangle with somthing that ought to be simple.
>
>There are 6 stainless tubes which slide into the three bits of rubber tube
>that make the mountings for the exhaust. Can anyone give me an idea of how
>long the vertical elements were (hole center to hole center) when it was all
>in the right place? Did you shorten the stainless tubes to around 3" overall
>from 5"? Did the horizontal mounting end up clear below the mixture cable?
>
>Thanks, Steve.
>#90360
>exhaust
>UK
>
>
>
--
David Edgemon
Summit Research Corp.
Huntsville Al.
"On the side of the software box, in the 'System Requirements' section,
it said 'Requires Windows 95 or better'. So I installed Linux."
-Anonymous
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|