---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Mon 01/12/04: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 07:26 AM - Re: RV9-List Digest: 3 Msgs - 01/11/04 (david edgemon) ________________________________ Message 1 _____________________________________ Time: 07:26:48 AM PST US From: david edgemon Subject: RV9-List: Re: RV9-List Digest: 3 Msgs - 01/11/04 --> RV9-List message posted by: david edgemon Steve, I recently installed my exhaust on a O-320 D1A. I cut the stainless tubes down from their delivered length (4.5 ?) to about 3 incheds. This works well. I ended up with approx 1 inch of tube in the rubber tubing on each leg. The horizontal tube ran under the mixture and throttle cables just above the nose gear leg. Note: You should mount the cabin heat muff first since these exhaust hangers will have to go around it. Ask me how I know. :-) Good Luck >________________________________ Message 1 _____________________________________ > > >Time: 10:37:19 AM PST US >From: "Steve Sampson" >Subject: RV9-List: exhaust > >--> RV9-List message posted by: "Steve Sampson" > >I seem tp be getting in a tangle with somthing that ought to be simple. > >There are 6 stainless tubes which slide into the three bits of rubber tube >that make the mountings for the exhaust. Can anyone give me an idea of how >long the vertical elements were (hole center to hole center) when it was all >in the right place? Did you shorten the stainless tubes to around 3" overall >from 5"? Did the horizontal mounting end up clear below the mixture cable? > >Thanks, Steve. >#90360 >exhaust >UK > > > -- David Edgemon Summit Research Corp. Huntsville Al. "On the side of the software box, in the 'System Requirements' section, it said 'Requires Windows 95 or better'. So I installed Linux." -Anonymous