Today's Message Index:
----------------------
1. 08:43 AM - slider bows (kerrjohna@comcast.net)
2. 08:01 PM - Wire runs through center section (Matthew Brandes)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: kerrjohna@comcast.net
okay guys, I need some help getting unflumuxed. been working all week on shaping
the slider bows and have been able to do pretty well on the rear 1/8-3/16 inside
the aft deck skin. the side bows follow the side skin curve but are inset
about 3/16" along their entire length. BUT....
the front bow can be made to follow the arc of the roll bar but it is currently
about 3/4" above the bar at centerline and about 3/8" at 10:00 and 2:00 and 0
at the rollers. If I bring the center down, the corners go further out. cutting
down the tube would bring it in line as would shimming the roll bar, neither
of which is immediately appealing.
TIA for you help.
John
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Wire runs through center section |
--> RV9-List message posted by: "Matthew Brandes" <matthew@n523rv.com>
I'm starting on my fuselage center section and I've read where most people
wish they would have drilled additional holes for wiring runs.
Ok.. where would you have put them??? I'd like to benefit from those of
have gone before me and drill them now instead of later.
Matthew Brandes
Van's RV-9A (Wings/Fuselage)
EAA Chapter 91 & 868
www.n523rv.com
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|