---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Fri 01/30/04: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 08:43 AM - slider bows (kerrjohna@comcast.net) 2. 08:01 PM - Wire runs through center section (Matthew Brandes) ________________________________ Message 1 _____________________________________ Time: 08:43:01 AM PST US From: kerrjohna@comcast.net Subject: RV9-List: slider bows --> RV9-List message posted by: kerrjohna@comcast.net okay guys, I need some help getting unflumuxed. been working all week on shaping the slider bows and have been able to do pretty well on the rear 1/8-3/16 inside the aft deck skin. the side bows follow the side skin curve but are inset about 3/16" along their entire length. BUT.... the front bow can be made to follow the arc of the roll bar but it is currently about 3/4" above the bar at centerline and about 3/8" at 10:00 and 2:00 and 0 at the rollers. If I bring the center down, the corners go further out. cutting down the tube would bring it in line as would shimming the roll bar, neither of which is immediately appealing. TIA for you help. John ________________________________ Message 2 _____________________________________ Time: 08:01:19 PM PST US From: "Matthew Brandes" Subject: RV9-List: Wire runs through center section --> RV9-List message posted by: "Matthew Brandes" I'm starting on my fuselage center section and I've read where most people wish they would have drilled additional holes for wiring runs. Ok.. where would you have put them??? I'd like to benefit from those of have gone before me and drill them now instead of later. Matthew Brandes Van's RV-9A (Wings/Fuselage) EAA Chapter 91 & 868 www.n523rv.com