Today's Message Index:
----------------------
1. 06:58 AM - Re: Wire runs through center section (david edgemon)
2. 11:04 AM - [ Greg Gruninger ] : New Email List Photo Share Available! (Email List Photo Shares)
3. 11:05 AM - [ Rob Ray ] : New Email List Photo Share Available! (Email List Photo Shares)
4. 11:18 AM - [ Jerry Calvert ] : New Email List Photo Share Available! (Email List Photo Shares)
5. 04:57 PM - RV-9A Kit For Sale (Fabian Lefler)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Wire runs through center section |
--> RV9-List message posted by: david edgemon <dedgemon@knology.net>
Mathew,
I finished my wiring over the holidays and did indeed drill a few extra
holes for wiring.
A lot depends on what you are doing with electronics back in the tail.
Here's what I did.
1. I have the MANUAL elevator trim so no servo wiring but it takes up
one side of the center tunnel.
I placed the strobe supply in the baggage area plus I had wires for
the Dynon external magnetometer
going to the tail.
2. I ran wiing for the magnetometer and power for the strobe supply in
the center tunnel along with the
manual trim cable.
3. I drill holes for snap bushings along both sides of the fuse down
along the area where the flap pushrods
go. This allowed me to run the wing strobe cables under the fuselag
floor and out the aileron pushrod
hole and down the wing. I used 5/8 inch snap bushings which gave
plenty of extra room for the other
odds and ends that you'll forget about until its time to run wires.
Good Luck
P.S.
Oh yeah, I also drilled an additional snap bushing hole in the spar
center section in order to pass the wiring going to
the center tunnel area and out the wings.
I ended up building a main wiring bundle that drops down the firewall
alongside the cabin heater vent area and then
runs alongside the fuel and brake lines. These wires then split up at
the spar with most going through to the floor area
and either out the wings or to the tail.
Hope it helps
>--> RV9-List message posted by: "Matthew Brandes" <matthew@n523rv.com>
>
>I'm starting on my fuselage center section and I've read where most people
>wish they would have drilled additional holes for wiring runs.
>
>Ok.. where would you have put them??? I'd like to benefit from those of
>have gone before me and drill them now instead of later.
>
>Matthew Brandes
>Van's RV-9A (Wings/Fuselage)
>EAA Chapter 91 & 868
>www.n523rv.com
>
>
--
David Edgemon
Summit Research Corp.
"Under system requirements it said install Windows 95
or better, so I installed Linux"
Anonymous
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | [ Greg Gruninger ] : New Email List Photo Share Available! |
--> RV9-List message posted by: Email List Photo Shares <pictures@matronics.com>
A new Email List Photo Share is available:
Poster: Greg Gruninger <GGrun5673@gbronline.com>
Subject: Completed RV-8!
http://www.matronics.com/photoshare/GGrun5673@gbronline.com.01.31.2004/index.html
o Main Photo Share Index
http://www.matronics.com/photoshare
o Submitting a Photo Share
If you wish to submit a Photo Share of your own, please include the
following information along with your email message and files:
1) Email List or Lists that they are related to:
2) Your Full Name:
3) Your Email Address:
4) One line Subject description:
5) Multi-line, multi-paragraph description of topic:
6) One-line Description of each photo or file:
Email the information above and your files and photos to:
pictures@matronics.com
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | [ Rob Ray ] : New Email List Photo Share Available! |
--> RV9-List message posted by: Email List Photo Shares <pictures@matronics.com>
A new Email List Photo Share is available:
Poster: Rob Ray <smokyray@yahoo.com>
Subject: RV-FOUR (Editor's Note: WOW!!)
http://www.matronics.com/photoshare/smokyray@yahoo.com.01.31.2004/index.html
o Main Photo Share Index
http://www.matronics.com/photoshare
o Submitting a Photo Share
If you wish to submit a Photo Share of your own, please include the
following information along with your email message and files:
1) Email List or Lists that they are related to:
2) Your Full Name:
3) Your Email Address:
4) One line Subject description:
5) Multi-line, multi-paragraph description of topic:
6) One-line Description of each photo or file:
Email the information above and your files and photos to:
pictures@matronics.com
Message 4
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | [ Jerry Calvert ] : New Email List Photo Share Available! |
--> RV9-List message posted by: Email List Photo Shares <pictures@matronics.com>
A new Email List Photo Share is available:
Poster: Jerry Calvert <rv6@cox.net>
Subject: Leather Interior
http://www.matronics.com/photoshare/rv6@cox.net.01.31.2004/index.html
o Main Photo Share Index
http://www.matronics.com/photoshare
o Submitting a Photo Share
If you wish to submit a Photo Share of your own, please include the
following information along with your email message and files:
1) Email List or Lists that they are related to:
2) Your Full Name:
3) Your Email Address:
4) One line Subject description:
5) Multi-line, multi-paragraph description of topic:
6) One-line Description of each photo or file:
Email the information above and your files and photos to:
pictures@matronics.com
Message 5
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
<RV7and7A@yahoogroups.com>
| Subject: | RV-9A Kit For Sale |
--> RV9-List message posted by: "Fabian Lefler" <fablef@bellsouth.net>
It is with a heavy heart I post this message to the various lists. Personal
issues (not financial) are forcing me to sell my beloved RV-9A kit. I have
labored over this kit for the past 3 years, and consider it to be a very
well built and good looking airplane. I would love to sell it to someone in
the area who can appreciate some occasional, and FREE, help from me to
complete the kit.
THIS AIRPLANE COULD BE FLYING IN LESS THAN A COUPLE OF MONTHS.
You can see some photos and detailed description here:
http://www.affordablepanels.com/rv9aforsale.htm
The Kit Includes:
-Eggenfellner Firewall Forward Package - Normally Aspirated (Installed).
-MT 3 Blade Propeller (Still in Crate).
-Altrak Altitude Hold (Installed).
-Trio Avionics Autopilot (Installed).
-Aeroflash Nav and Strobe Lighting.
-Interior by Cleveland Tools with plenty of extra fabric.
-Fuselage is on its gear and Canopy Work is finished with all skirts
installed.
-Modular Panel (Installed), but no instrument holes have been cut out.
-Much more.
Please NO E-MAILS. If you are interested, please call me at 561-641-9737
Thank You
Fabian
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|