Today's Message Index:
----------------------
1. 04:00 AM - Re:Cowl hinge (Neilekins@aol.com)
2. 06:54 AM - Re:Cowl hinge (Dale Larsen)
3. 06:58 AM - Re: Re:Cowl hinge (Neilekins@aol.com)
4. 07:47 AM - Re: Manual trim cable routing through 706 bulkhead (Leland)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: Neilekins@aol.com
Has any one had any problems with the hinge that connects the engine cowling
to the firewall breaking on an RV 9 ?
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: "Dale Larsen" <slickrock@been-there.com>
> Has any one had any problems with the hinge that connects the engine
cowling
> to the firewall breaking on an RV 9 ?
Haven't heard about the 9, but a few of my RV6 friends suggested I use the
extruded hinge on the bottom part of the firewall, you know the two strips
on each side of the exhaust pipes. They suggested this because theirs had
broken and had to be replaced.
Hope that helps,
Dale
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: Neilekins@aol.com
Yes, it does thanks. I have heard that a couple of people were having
problems. They did a couple of modifications to stop that.. Thanks Neil
Message 4
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Manual trim cable routing through 706 bulkhead |
1.7 SUBJ_HAS_SPACES Subject contains lots of white space
--> RV9-List message posted by: Leland <Federigo@pacbell.net>
Matthew, I did the same as Sargent. I drilled out a hole beside the
Square opening and put in a grommet large enough for the Trim Cable and
tail light wire. My strobe power supply and ELT are mounted under and on
the baggage floor and so their wires penetrate the baggage bulkhead
separately.
Leland
RV9A Quickbuild
Mounting Dynon pitot probe in Gretz mount
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|