---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Tue 07/27/04: 4 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 04:00 AM - Re:Cowl hinge (Neilekins@aol.com) 2. 06:54 AM - Re:Cowl hinge (Dale Larsen) 3. 06:58 AM - Re: Re:Cowl hinge (Neilekins@aol.com) 4. 07:47 AM - Re: Manual trim cable routing through 706 bulkhead (Leland) ________________________________ Message 1 _____________________________________ Time: 04:00:41 AM PST US From: Neilekins@aol.com Subject: RV9-List: Re:Cowl hinge --> RV9-List message posted by: Neilekins@aol.com Has any one had any problems with the hinge that connects the engine cowling to the firewall breaking on an RV 9 ? ________________________________ Message 2 _____________________________________ Time: 06:54:01 AM PST US From: "Dale Larsen" Subject: RV9-List: Re:Cowl hinge --> RV9-List message posted by: "Dale Larsen" > Has any one had any problems with the hinge that connects the engine cowling > to the firewall breaking on an RV 9 ? Haven't heard about the 9, but a few of my RV6 friends suggested I use the extruded hinge on the bottom part of the firewall, you know the two strips on each side of the exhaust pipes. They suggested this because theirs had broken and had to be replaced. Hope that helps, Dale ________________________________ Message 3 _____________________________________ Time: 06:58:09 AM PST US From: Neilekins@aol.com Subject: Re: RV9-List: Re:Cowl hinge --> RV9-List message posted by: Neilekins@aol.com Yes, it does thanks. I have heard that a couple of people were having problems. They did a couple of modifications to stop that.. Thanks Neil ________________________________ Message 4 _____________________________________ Time: 07:47:34 AM PST US From: Leland Subject: RV9-List: Re: Manual trim cable routing through 706 bulkhead 1.7 SUBJ_HAS_SPACES Subject contains lots of white space --> RV9-List message posted by: Leland Matthew, I did the same as Sargent. I drilled out a hole beside the Square opening and put in a grommet large enough for the Trim Cable and tail light wire. My strobe power supply and ELT are mounted under and on the baggage floor and so their wires penetrate the baggage bulkhead separately. Leland RV9A Quickbuild Mounting Dynon pitot probe in Gretz mount