Today's Message Index:
----------------------
1. 09:59 AM - Re: Pitot tube hole (Leland)
2. 05:28 PM - Van's Homecoming-- Where to eat (Richard Scott)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Pitot tube hole |
--> RV9-List message posted by: Leland <Federigo@pacbell.net>
Bill, to fill the old pitot tube hole, I epoxied a sheet of Alclad on
the backside. After curing, I filled the indentation with fiberglass,
and after curing that, I finished it with Superfill.
Here is a hint: when you install the Gretz mount, DO NOT rivet it to the
wing skin until after riveting on the skin.
Also, my Dynon did not go deep enough into the Gretz to get sufficient
edge clearance for the screws that hold on the Dynon. I had to do some
hand filing to get the two to mate.
Leland
Cleaning up the wiring
"As I built the wings I diligently followed Van's directions and drilled
the hole for the pitot tube when they called for it. Now, before I
close up the wings I realized I would like to install the Dynon EFIS
unit along with their pitot tube so I can also have an AOA indicator.
The problem is that the bracket I bought to hold the pitot tube doesn't
cover the hole I have already drilled for the Van's tube.
What do you suggest I do?
A) Leave the hole open?
B) Drill out the two adjacent rivets and put a small plate behind the
spar web flange to cover the hole and put move the Pitot tube down?
C) Return the Dynon pitot tube, due w/o the AOA, and just use the Dynon
EFIS with the Van's pitot?"
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
rv7-list@matronics.com, rv10-list@matronics.com, rv8-list@matronics.com,
rv3-list@matronics.com, rv4-list@matronics.com
| Subject: | Van's Homecoming-- Where to eat |
1.70 SUSPICIOUS_RECIPS Similar addresses in recipient list
--> RV9-List message posted by: Richard Scott <rscott@cascadeaccess.com>
Scrumptous breakfast both Saturday & Sunday will be served right at
Van's--pancakes, eggs, ham, sausage, bacon, coffee & orange juice. And
lunch on Saturday, burgers, corn on the cob.
Served by EAA Chapter 902. Don't miss out!
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|