Today's Message Index:
----------------------
1. 05:53 AM - SW wash primer (Jim Wright)
2. 09:57 AM - Fw: Slider (Richard Scott)
3. 11:11 AM - Re: Diesel engines in RV9 (fcs@jlc.net)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: "Jim Wright" <jlwright@cox-internet.com>
I had the same problem the first time I used the SW wash primer. Another
RV builder solved my problem. The first thing you have to do is stir the
paint with a drill motor long enough to completely mix the paint. The
second is to mix the paint one part paint to two parts activator instead
of one to one and a half. After I did that it works great and sticks
like concrete. After I mixed the paint the first time it doesn't take
but a minute to remix it later when you get ready to paint again, but it
is necessary to stir the paint very well. I've used PPG 271 epoxy primer
over the Sherwin Williams wash primer and then top coated and had no
problem with adhesion or reactions.
Jim Wright
RV-9A 90919
Empennage finished working on wings
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: Richard Scott <rscott@cascadeaccess.com>
>Listers,
This apparently was sent directly to me by mistake from a Bryan
Carr. Relevant to the slider vs. tip-up discussion.
Richard Scott
>Had a friend go into the water after an engine failure.
>He had a tip up.
>The aircraft flipped over when the gear hit.
>He couldn't get the canopy open.
>He and his passenger drowned.
>Get a slider.
>
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Diesel engines in RV9 |
--> RV9-List message posted by: "fcs@jlc.net" <fcs@jlc.net>
> David Wilson
> Ready to order kit with 3 friends
I didn't know this was an option back when I ordered my kit #59. They
just started calling at all hours and showing up at the workshop. Now that
I'm flying, there's even more of them! (sorry, I couldn't resist ;
)
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|