---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Tue 12/14/04: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 05:42 AM - Re: Elevator balance (Dale Larsen) 2. 11:10 AM - Re: Trim Cable (Peter Laurence) 3. 11:28 AM - Re: Trim Cable (Richard Tasker) ________________________________ Message 1 _____________________________________ Time: 05:42:09 AM PST US From: "Dale Larsen" Subject: Re: RV9-List: Elevator balance --> RV9-List message posted by: "Dale Larsen" Steve, If you mean the airplane is tail heavy in flight, you can adjust this by shimming the front of the vertical stab. Adjust it so that the elevator is neutral when you are straight and level. You will notice that the front mount for the VS is designed so that this is quite easy. Don't go more that .020 inch at a time. If you mean the static balance of the elevator, paint could upset this a bit. There is more elevator surface area on the trail side of the hinge. Therefore more paint, more weight. Static balance is easily corredted by adding or removing more weight. The balance of the elevator, if I understand correctly is mostly to prevent flutter. A slight imbalance should not have much of an effect at all in flight. The effect of gravity on an elevator travelling at 100 KTS is negligible compared to the aerodynamic forces. If both elevators are static balanced individually, then the pair will be static balanced when tied together. However on another pair, one could be heavy on the leading side, the other equally heavy on the trailing side and both would balance out as a pair. They would not balance individually. Which is better? I don't know for sure, but I don't think it matters much at all. I balanced mine individually, and it took no adjustments when they were tied together as one. And it flys just fine.... REALLY fine. Dale > Now they are painted the elevator with the electric trim in it is tail > heavy. Is it important they are balanced individually, or just as a pair > since they effectively become one? > Thanks, Steve. > #90360 ________________________________ Message 2 _____________________________________ Time: 11:10:01 AM PST US From: Peter Laurence Subject: Re: RV9-List: Trim Cable --> RV9-List message posted by: Peter Laurence Try Eric Jones' site at http://www.periheliondesigns.com He has a trim wheel that can control a MAC or RAC servo so that the only connection is two 22ga wires. Peter ----- Original Message ----- From: "D.Munz" <182ppl@comcast.net> Subject: RV9-List: Trim Cable > --> RV9-List message posted by: "D.Munz" <182ppl@comcast.net> > > Has anyone seen a trim wheel system installed in an RV ala cessna, piper > instead of the vernier control? > > > ________________________________ Message 3 _____________________________________ Time: 11:28:58 AM PST US From: Richard Tasker Subject: Re: RV9-List: Trim Cable --> RV9-List message posted by: Richard Tasker Actually you would do better to use http://www.periheliondesign.com (no "s"). ;-) Dick Tasker Peter Laurence wrote: >--> RV9-List message posted by: Peter Laurence > >Try Eric Jones' site at http://www.periheliondesigns.com > >He has a trim wheel that can control a MAC or RAC servo so that the only >connection is two 22ga wires. > >Peter > > >