Today's Message Index:
----------------------
1. 10:25 PM - Centre section bolts (D,C,Jones)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Centre section bolts |
--> RV9-List message posted by: "D,C,Jones" <cliffjones@look.ca>
I'm at the stage of fitting the 904 centre sections together with the spacers to
match-drill the bottom skin and the 904 H side plates. The problem is with
the 7/16" bolts through the 904 centre sections being REALLY tight.
I realize that these need to have a really snug fit, but these bolts seem to be
too tight - I need to use a fairly heavy blow with the dead-blow hammer (soft
face) to get these bolts to move, even with them oiled. I don't want to damage
the bolts or the aluminum pieces.
Any suggestions? Please.
Cliff 9A wings/fuse
Chase, BC
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|