---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Wed 05/11/05:2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 01:39 AM - trim -manual- tab horns (Jef Vervoort) 2. 12:29 PM - Re: trim -manual- tab horns (Jef Vervoort) ________________________________ Message 1 _____________________________________ Time: 01:39:42 AM PST US From: "Jef Vervoort" Subject: RV9-List: trim -manual- tab horns --> RV9-List message posted by: "Jef Vervoort" Hello All, Does anyone know the seize of the hole where the nylon clevis 1032 is attached. I want to drill this hole in the two horns before priming, painting and riveting them to the tab. Thanks. Jef in Belgium; 91031. ________________________________ Message 2 _____________________________________ Time: 12:29:23 PM PST US From: "Jef Vervoort" Subject: RE: RV9-List: trim -manual- tab horns --> RV9-List message posted by: "Jef Vervoort" I was informed off list that the clevis pin is 1/8". Thanks. Jef. -----Oorspronkelijk bericht----- Van: owner-rv9-list-server@matronics.com [mailto:owner-rv9-list-server@matronics.com] Namens Jef Vervoort Verzonden: woensdag 11 mei 2005 10:39 Aan: rv9-list@matronics.com Onderwerp: RV9-List: trim -manual- tab horns --> RV9-List message posted by: "Jef Vervoort" Hello All, Does anyone know the seize of the hole where the nylon clevis 1032 is attached. I want to drill this hole in the two horns before priming, painting and riveting them to the tab. Thanks. Jef in Belgium; 91031.