Today's Message Index:
----------------------
1. 06:12 AM - Re: RV7-List: F-623 Baggage Compt Corner Ribs (Bob Collins)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | RE: RV7-List: F-623 Baggage Compt Corner Ribs |
--> RV9-List message posted by: "Bob Collins" <bcollinsrv7a@comcast.net>
Gerry:
I just did the same part the other day and that joggle confused me because
it suggests the flange fits inside the bulkhead flange. But if you do that,
you can't get the edge of the corner rib to line up flush with the bottom
skin, although I have seen some Web sites that have suggested cutting aroudn
etc.
Don't bother.
Hack it off. The two flanges, the web,etc whee it meets the flange of the
side of the bulkhead and the top. Front and back (I left the back intact
until we mated the center and aft section on Thursday and then it was much
easier to see why you have to do the same to the rear section.
It takes awhile to see this on the plans. They really needed a zoomed-in
overhead shot here.
Disclaimer: I see you posted this to both the 9 and 7 groups. I'm building a
7. I have no idea if the situation is the same with the 9.
Bob
St. Paul
-----Original Message-----
From: owner-rv7-list-server@matronics.com
[mailto:owner-rv7-list-server@matronics.com] On Behalf Of Gerry Filby
Subject: RV7-List: F-623 Baggage Compt Corner Ribs
--> RV7-List message posted by: Gerry Filby <gerf@gerf.com>
Scratchin' my head once again ...
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|