---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Fri 06/03/05: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:12 AM - Re: RV7-List: F-623 Baggage Compt Corner Ribs (Bob Collins) ________________________________ Message 1 _____________________________________ Time: 06:12:03 AM PST US From: "Bob Collins" Subject: RV9-List: RE: RV7-List: F-623 Baggage Compt Corner Ribs --> RV9-List message posted by: "Bob Collins" Gerry: I just did the same part the other day and that joggle confused me because it suggests the flange fits inside the bulkhead flange. But if you do that, you can't get the edge of the corner rib to line up flush with the bottom skin, although I have seen some Web sites that have suggested cutting aroudn etc. Don't bother. Hack it off. The two flanges, the web,etc whee it meets the flange of the side of the bulkhead and the top. Front and back (I left the back intact until we mated the center and aft section on Thursday and then it was much easier to see why you have to do the same to the rear section. It takes awhile to see this on the plans. They really needed a zoomed-in overhead shot here. Disclaimer: I see you posted this to both the 9 and 7 groups. I'm building a 7. I have no idea if the situation is the same with the 9. Bob St. Paul -----Original Message----- From: owner-rv7-list-server@matronics.com [mailto:owner-rv7-list-server@matronics.com] On Behalf Of Gerry Filby Subject: RV7-List: F-623 Baggage Compt Corner Ribs --> RV7-List message posted by: Gerry Filby Scratchin' my head once again ...