Today's Message Index:
----------------------
1. 04:42 AM - Re: Wing conduit (rveighta)
2. 05:24 AM - Brake line toque (Randy Russell)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Wing conduit |
--> RV9-List message posted by: rveighta <rveighta@earthlink.net>
Gerry, the corrugated wing conduit can be stretched, thus making it smaller in
diameter. So
if you drill holes through the wing ribs of the diameter of the conduit between
the raised areas
then stretch it (takes two people), you'll find when you release it that it stays
put.
That's what I did on my Rv-8A, on my 8 I just routed wires and stuff through the
tooling
holes in the ribs and secured 'em with small tie wraps. Much easier ...........
Walt Shipley
-----Original Message-----
From: Gerry Filby <gerf@gerf.com>
Subject: Re: RV9-List: Wing conduit
--> RV9-List message posted by: Gerry Filby <gerf@gerf.com>
I used the Van's stuff too - but I found the corrugation
annoying to work with - isn't there a white non-corrugated type
available from somewhere ? And why is it corrugated - what's
the benefit ?
g
>
> --> RV9-List message posted by: "Tom Callender" <tcallender@alltel.net>
>
>
> ----- Original Message -----
> From: "D.Munz" <182ppl@comcast.net>
> To: <rv9-list@matronics.com>
> Subject: RV9-List: Wing conduit
>
>
> > --> RV9-List message posted by: "D.Munz" <182ppl@comcast.net>
> >
> > Will anyone tell me where to buy the wiring conduit for the wings and what
> > outside and inside diameter it should be?
> >
>
> From Van's Accessories Catalog. Nylon corrugated tube. 0.810" OD. Duct
> NT5/8, 25 or 50ft rolls. Use 3/4" dia holes.
> Tom C
> RV9 N793JT (reserved)
>
>
>
>
>
>
>
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Brake line toque |
--> RV9-List message posted by: "Randy Russell" <rer51@netscape.ca>
What is the recommended torque for the ferrel nuts that connect the high pressure
line to the master cylinders? Already searched archives. Randy RV9A Finishing
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|