---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Tue 06/21/05: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 09:33 AM - Gear fairing clamp: was: Bad instructions for nosewheel pant construction (Bob Kelly) ________________________________ Message 1 _____________________________________ Time: 09:33:27 AM PST US From: Bob Kelly Subject: RV9-List: Gear fairing clamp: was: Bad instructions for nosewheel pant construction --> RV9-List message posted by: Bob Kelly Just as a question (I'm getting real close to doing the fiberglass,) has anyone tried the safety wire type clamp on the gear leg fairing? I made one of the clamp-makers after seeing one at Oshkosh last year. It clamps as good as any hose clamp and of course they are very light and inexpensive, once you have the machine. Since they don't stick up at all, I would think they would work really well in this application, but I haven't tried them on fiberglass. Putting them on takes some space for the machine, but I doubt if this is an issue. Two or three double loops should hold anything. If you haaven't seen one of these devices, I found one at http://www.gemplers.com/a/shop/product.asp?T1=HC8&src=21TL002 Bob Kelly On 06/21/05, Sargentclt@cs.com wrote: > --> RV9-List message posted by: Sargentclt@cs.com > > Great news I had the same issue on my 7A. When all is said and done you > may need a new ring clamp to hold the leg fairing in place. I get a gentle > rub at full turn of the wheel. I also noticed the clamp is visible so I > made a fairing on the from cap to hide it. Wait till you get to the baffle > install. These plans are written in crayon. > > Tad Sargent > Sargentclt(at)CS.com > RV7A > > > > > > > Regards --