Today's Message Index:
----------------------
1. 12:07 AM - Re: Flap pushrod cutout (Albert Gardner)
2. 02:42 AM - Re: Flap pushrod cutout (jc@INFONET.COM.BR)
3. 07:01 AM - Flap pushrod cutout (Merems)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Flap pushrod cutout |
--> RV9-List message posted by: "Albert Gardner" <ibspud@adelphia.net>
After you install the wings and flaps, you hook up the flaps to the flap
actuator tube and cut away any skin that interferes with flap movement as it
goes up and down. That will give you the smallest hole possible. Afterward,
you cleanup/trim away more skin as required for adequate clearance in use.
Albert Gardner
9-0132 N872RV
Yuma, AZ
-----Original Message-----
From: owner-rv9-list-server@matronics.com
[mailto:owner-rv9-list-server@matronics.com] On Behalf Of Merems
Subject: RV9-List: Flap pushrod cutout
--> RV9-List message posted by: "Merems" <merems@cox.net>
Fellow builders,
I am preparing my bottom center fuselage skin for riveting and I am trying
to determine the cutout size for the flap pushrod. I have had the side
skins on and I know there is a slot cut in the side skin for the flap
pushrod. There is a 3/32 hole in bottom skin that lines up with this slot.
I believe this slot and hole are to joined/enlarged together to form the
slot for the pushrod, however I can't seem to find the proper reference in
the drawings or instructions.
If you can enlighten me I would appreciate it.
Paul
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | RE: Flap pushrod cutout |
--> RV9-List message posted by: jc@infonet.com.br
Hi Merens:
Leave this job to the final assembly. After the wings and flaps are in their place.
It
will be easier to trim the smallest hole necessary.
JC - Aracaju - Brasil
-9A QB
#90997
flying
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Flap pushrod cutout |
--> RV9-List message posted by: "Merems" <merems@cox.net>
Gents,
Thanks for the input on the flap pushrod cutout. I had thought that because of
the advanced nature of the kit Van's would have given more information on the
cutout. I thought I was having a senior moment (not finding it in the plans or
instructions).
Paul
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|