----------------------------------------------------------
                           RV9-List Digest Archive
                                      ---
                     Total Messages Posted Sun 11/27/05: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 08:38 AM - Re: Tip-up mounting question  ()
     2. 01:41 PM - Just A Few More Days Left; Lagging Behind Last Year...  (Matt Dralle)
 
 
 
________________________________  Message 1  _____________________________________


Time: 08:38:32 AM PST US
From: <dthomas773@sbcglobal.net>
Subject: Re: RV9-List: Tip-up mounting question

--> RV9-List message posted by: <dthomas773@sbcglobal.net>

I had a bit of consternation with this little assembly
as well.  For a relatively small part it requires
quite a bit of time.
I remember calling Van's complaining the curved parts
were not square and there reply was, "well straighten
them". Actually when you fit and rivet the parts
together you can pull them straight.

Dennis Thomas
RV9  N164DV  245 hours

--- Merems <merems@cox.net> wrote:

> --> RV9-List message posted by: "Merems"
> <merems@cox.net>
> 
> Fellow Tip-Up builders,
> 
> I am in the process of building the roll bar/frame
> for my RV-7A.  The frame halves are very warped and
> the flanges aren't 90 as needed.  It has taken some
> time to adjust the flanges but the parts are still
> warped.  I haven't drilled the inner supporting
> strips yet, that's tomorrows adventure.
> 
> Anyway I have included a photo of the mounting
> brackets in there approximate position and note the
> interference with the seat back stop on the top side
> of the bulkhead (circled area).  I believe this is
> common, but I haven't seen too many photos of this
> interference.  I am considering taking a dremel tool
> and removing the offending material on the seat back
> stop.
> 
> What have you done to correct this?  Am I the only
> one (I doubt it)?
> 
> Paul
> 
> 
>
> Click on
> about
> provided
> www.buildersbooks.com,
> Admin.
> _->
> browse
> Subscriptions page,
> FAQ,
>
> 
> 
> 
> 
> 






________________________________  Message 2  _____________________________________


Time: 01:41:39 PM PST US
From: Matt Dralle <dralle@matronics.com>
Subject: RV9-List: Just A Few More Days Left; Lagging Behind Last Year...

--> RV9-List message posted by: Matt Dralle <dralle@matronics.com>


Dear Listers,

There are just four more days left of this year's List Fund Raiser!  Response has
been very good, but we are behind last year as far as the number of people
that have made a Contribution and as a percentage of the total number of subscribers.

Please remember that there isn't any sort of commercial advertising on the Lists
and the *only* means I have of keeping these Lists running through your Contributions
during this Fund Raiser.

Please make a Contribution today!

        http://www.matronics.com/contribution

Thank you!

Matt Dralle
Matronics Email List Administrator


Matt G Dralle | Matronics | PO Box 347 | Livermore | CA | 94551
925-606-1001 V | 925-606-6281 F | dralle@matronics.com Email
http://www.matronics.com/ WWW | Featuring Products For Aircraft
do not archive