---------------------------------------------------------- RV9-List Digest Archive --- Total Messages Posted Tue 04/18/06: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:26 AM - Re: E-Mags (DellAngelo, Scott M) 2. 09:16 AM - Fw: Emags (gbrasch@earthlink.net) ________________________________ Message 1 _____________________________________ Time: 06:26:33 AM PST US Subject: RV9-List: Re: E-Mags From: "DellAngelo, Scott M" --> RV9-List message posted by: "DellAngelo, Scott M" I have an e-mag and p-mag in mine. I have fought some high CHT's but after drilling out my carb jet to #38 to help solve my lean issue my CHT's are staying under 400 degrees on all cylinders at cruise. So, I am happy with mine. They have been back for re-mapping once, but starting recently they are shipping with a firmware capable of using software to load in changes. I was told I will have to send mine in one more time to get that firmware in mine so that I will then be able to make the changes. Your mileage my vary but that is where I am at. Scott #90598 - N598SD Flying - 13.5 hrs Plainfield, IL Scott -------------------------- Sent from my BlackBerry Wireless Handheld ________________________________ Message 2 _____________________________________ Time: 09:16:12 AM PST US From: gbrasch@earthlink.net Subject: RV9-List: Fw: Emags --> RV9-List message posted by: gbrasch@earthlink.net This, from a friend on the Emag issue. Glenn in Arizona -9A finishing kit ordered. -----Forwarded Message----- >From: "Darwin N. Barrie" >Sent: Apr 17, 2006 5:49 PM >To: Glenn Brasch >Subject: Emags > >You can forward this to your 9 list. > >So far I have 55 hours of time on my Emag and Pmag system. The install was very easy. Hint here, install before the engine is on the airframe for even easier install. > >I have not had any temperature issues at all. My only temp issue is with the oil and the method the oil cooler was mounted. No abnormal CHT or EGT issues. > >I recommend that the timing be checked and make sure the programming switches are in the right positions. > >I like them and would recommend the Emag Pmag system to anyone. > >Not affiliated with the company, just a satisfied customer. > >Darwin N. Barrie >Chandler AZ >RV-7 N717EE >ECI IO 360