Today's Message Index:
----------------------
1. 03:45 PM - Aft CG (Chenoweth)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> RV9-List message posted by: "Chenoweth" <chenoweth@gwi.net>
This is a question for any of you with a completed tailwheel 9. I'm in
the tail cone and mid section construction part of one and wonder about
CG problems. I'm hoping to use a wooden prop and worry that I'll end up
with a very aft CG if I do. That is leading me to wonder if ELT and
strobe power supply placement should be other than behind bulkhead 706
(which is where Van's strongly recommends I put them).
Any comments and suggestions on this will be gratefully received.
Bill
Albion, Maine
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|