Today's Message Index:
----------------------
1. 04:41 PM - Re: Instrument panel (Matthew Brandes)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RE: Instrument panel |
Wayne,
I did the modification to move the support ribs over several inches to
allow for a 'centering' of the instruments. It was a bit of work and
I probably wouldn't do it again. Primarily because it puts that center
instrument dead in line with the support rib between the fw and
subplanel. On my panel, right below the AH I have a KI-209A CDI that is
fairly long and I had a helluva time getting the connector attached to
it because the wires couldn't come straight into the back.
Personally, stick with the stock setup and just offset the instruments a
bit. It may save you some headache down the road.
Matthew
RV-9A :: N523RV
www.n523rv.com
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|