Today's Message Index:
----------------------
1. 07:00 PM - cowl hinges (Mick Muller)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
I have been checking on my cowl preparations and installation
instructions for my RV9A. It has an O320E3D engine installed in it. The
finish kit has one aluminium hinge 6ft long for joining the two cowl
halves together, fairly easy to identify. However, the Vans contents lists
says
there is also 9 ft of 1/8 piano hinge. Exactly what dimension does the 1/8
refer to? Is it supposed to be the width of the hinge, the thickness of the
hinge, or the diameter of the pins?(1/8 does not fit any of these
measurements).
I received not one nine foot length, but a six foot length and a three foot
length. I also received thee other three foot lengths of piano hinge which
are of a lighter gauge, (two are 1/16 inch thick, the third piece slightly
thicker) but are not as wide as the six foot and three foot larger ones.
Does anyone know where each bit resides?
I emailed Vans with this question, but after 5 days have received no reply,
perhaps they are busy getting ready for sun'n'fun.
Thanks,
Mick Muller,
Builder 90701
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|