Today's Message Index:
----------------------
1. 09:34 PM - Re: RV7-List: FLUTING Ribs to match desired taper of VS (Don Hall)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RE: RV7-List: FLUTING Ribs to match desired taper of VS |
No. The instructions don't say to match contour. 90 deg works.
Matching the contour really comes into play on the fuse bulkheads..
******************************************
Don Hall
N517DG (registered)
rv7 fuselage
http://rv7.donka.net
******************************************
-----Original Message-----
From: owner-rv7-list-server@matronics.com
[mailto:owner-rv7-list-server@matronics.com] On Behalf Of Garey Wittich
Sent: Thursday, September 06, 2007 4:03 PM
Subject: RV7-List: FLUTING Ribs to match desired taper of VS
--> RV7-List message posted by: Garey Wittich
--> <gareywittich2000@yahoo.com>
Greetings:
Have an '"older" empennage and instructions dating back to 1999. Understand
RV-7, 8 and 9 have the same Vert Stabilizer. Is there anything in the
"Newer Instructions" about about tapering (angling) the flanges of the VS
Ribs to match the desired contour
(taper) of the VS ???
Thanks, Garey
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|