Today's Message Index:
----------------------
1. 02:48 PM - Re: Oil temp (Wayne)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Yes I attached a Fluke thermocouple meter next to the thermistor and
heated them with a heat gun. It read the same on the meter and the
Advanced Fight EFIS within 10 degrees.
Thanks for the suggestion.
Wayne
----- Original Message -----
From: cam andres
To: rv9-list@matronics.com
Sent: Wednesday, January 28, 2009 10:47 PM
Subject: Re: RV9-List: Oil temp
Wayne,
Have you verified the temperature indicating components are accurate?
I would make sure that a bench test confirms their accuracy before going
to the next step.
Cam Andres
RV9A under construction
On Wed, Jan 28, 2009 at 3:14 PM, Wayne <wowens@darientel.net> wrote:
With about 9 hours on my 9A I cant get the oil any hotter than 170
F and to do that I have to block off all the air flow to the cooler. I
am about to try insulating the oil lines.
I tried necking down the outlet air under the cowl . It started as
about 110 percent of the inlet area size and is now 92 percent . The
preliminary result is slightly cooler CHTs and EGTs and it goes 7 kts
faster. More testing is required when the weather breaks. The goal of
warming the oil more did not happen.
Any suggestions?
Wayne
et="_blank">http://www.matronics.com/Navigator?RV9-List
ttp://forums.matronics.com
_blank">http://www.matronics.com/contribution
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|