Today's Message Index:
----------------------
1. 06:17 PM - Conduit Placement in QB RV7 Wings (Bill Schlatterer)
2. 10:40 PM - Re: RV-List: Conduit Placement in QB RV7 Wings (John Morgensen)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Conduit Placement in QB RV7 Wings |
Can't decide if this is a good thing to do or not. I need to run conduit in
my QB wings but there are no consistent tooling holes anywhere except where
Vans put the pitot holes and the one tooling hole above that. (actually
below if the wing is right side up).
It would be pretty easy to put a 3/4 hole in place of the pitot holes and in
the tooling holes above with a 3/4 step drill and a 4 foot extension but it
would get pretty close to the spar. Is there an edge distance issue with
this or does it even apply? Doing it anywhere else without the tooling
holes is problematic?
Any comments, suggestions, pictures appreciated.
Bill S
RV7 only the wings left,..
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: RV-List: Conduit Placement in QB RV7 Wings |
Bill Schlatterer wrote:
>
> Can't decide if this is a good thing to do or not. I need to run
> conduit in my QB wings but there are no consistent tooling holes
> anywhere except where Vans put the pitot holes and the one tooling
> hole above that. (actually below if the wing is right side up).
>
> It would be pretty easy to put a 3/4 hole in place of the pitot holes
> and in the tooling holes above with a 3/4 step drill and a 4 foot
> extension but it would get pretty close to the spar. Is there an edge
> distance issue with this or does it even apply? Doing it anywhere
> else without the tooling holes is problematic?
>
> Any comments, suggestions, pictures appreciated. <<...>>
>
>
> Bill S
> RV7 only the wings left,....
>
This is what I did: CPVC? (lighter than regular PVC) and joist hangers
from Big R Ranch Supply.
John Morgensen
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|