Today's Message Index:
----------------------
1. 10:12 AM - Re: Re: RV-List: Conduit Placement in QB RV7 Wings (Ralph Finch)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: RV-List: Conduit Placement in QB RV7 Wings |
I did something similar, but with these hangars from Terminal Town:
http://www.terminaltown.com/Pages/Page65.html
http://tinyurl.com/noxv5z
Ralph Finch
From: owner-rv9-list-server@matronics.com
[mailto:owner-rv9-list-server@matronics.com] On Behalf Of John Morgensen
Sent: Saturday, July 25, 2009 10:37 PM
Subject: RV9-List: Re: RV-List: Conduit Placement in QB RV7 Wings
Bill Schlatterer wrote:
Can't decide if this is a good thing to do or not. I need to run conduit in
my QB wings but there are no consistent tooling holes anywhere except where
Vans put the pitot holes and the one tooling hole above that. (actually
below if the wing is right side up).
It would be pretty easy to put a 3/4 hole in place of the pitot holes and in
the tooling holes above with a 3/4 step drill and a 4 foot extension but it
would get pretty close to the spar. Is there an edge distance issue with
this or does it even apply? Doing it anywhere else without the tooling
holes is problematic?
Any comments, suggestions, pictures appreciated. <<...>>
Bill S
RV7 only the wings left,..
This is what I did: CPVC? (lighter than regular PVC) and joist hangers from
Big R Ranch Supply.
John Morgensen
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|