Today's Message Index:
----------------------
1. 12:14 AM - [Auto-Reply] RV9-List Digest: 2 Msgs - 04/16/11 (ron@architechnique.com)
2. 03:26 PM - "Worn Out" CT-Q67 Cable Assembly (Warning!) (Matt Dralle)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | [Auto-Reply] RV9-List Digest: 2 Msgs - 04/16/11 |
I am away from the office and will return Monday, April 18th, 2011.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | "Worn Out" CT-Q67 Cable Assembly (Warning!) |
Dear Listers,
At 170 hours on my RV-8 now, the Prop control had become increasing more difficult
to move starting around 100 hours. The Mixture and Throttle have worked fine
and continue to. All three controls use the standard "Green" control cables
from Vans, typically a "CT-Qxx" part.
A couple of weeks ago, I disassembled the Governor end of the assembly and made
sure that there was no binding or issues on that end. I even lightly lubed up
the various moving bits. Yesterday, the Prop control became so difficult to
move that I had trouble cycling the prop during run up. I pulled the whole throttle
quadrant installation apart today to have a look. I got the cable completely
out of the airplane and there are NO outward signs of wear or abuse of
*any kind*. But even with the cable completely out of the plane and nothing
connected to either end, it is almost impossible to move the cable!! I have a
new CT-Q67 cable assembly for my front-mounted governor installation and I'm
going to install that next.
But, I wanted to give everyone a heads up on these CT-Q controls. These things
are built like they go on a Caterpillar Tractor, so I can't figure out why they
would wear out like this.
If one of these controls starts getting stiff and tight, its probably not going
to get any better. Replace it before it becomes a safety issue! Not a big deal
on the Prop control, but on a throttle or mixture it could be a serious concern.
Best regards,
Matt
-
Matt Dralle
RV-8 #82880 N998RV
http://www.mattsrv8.com - Matt's RV-8 Construction Blog
http://www.youtube.com/MattsRV8 - Matt's RV-8 HDTV YouTube Channel
Status: 170+ Hours Total Time Since May 2 2010 Test Flight!
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|