Today's Message Index:
----------------------
1. 07:19 AM - Re: F684 gusset, RV-6 (Jim Oke)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | F684 gusset, RV-6 |
--> RVCanada-List message posted by: Jim Oke <wjoke@shaw.ca>
Hi Pat;
Situation with the F-684 is that it is attached to the outboard side of the
vertical angle on the firewall and then falls inside of the wd-603 engine
mount weldment which is sandwiched between the F-684 and the 3/4 x 3/4 x
.125 alum angle that runs from the firewall to the F-604. The forward 4" or
so of the horizontal flange of this angle is removed to allow this to
happen.
In other words, the F-684 does not reach as far as the large 1 x 1 1/4 x
.125 angle. The bottom edge of the F-684 overlaps the inside of the wd-603
by about 3/4" to pick up the 5 AN426AD-4-8 rivets that go through the
fuselage skin, the 3/4x3/4x.125 andle, the wd-603, and the F-684 in that
order. The bend line in the F-684 should roughly match the top (bottom in
jig) of the 3/4" diagonal angle.
As usual a few pictures should help so see attached.
Cheers, Jim
-----Original Message-----
From: owner-rvcanada-list-server@matronics.com
[mailto:owner-rvcanada-list-server@matronics.com] On Behalf Of pat morency
Subject: RVCanada-List: F684 gusset, RV-6
--> RVCanada-List message posted by: pat morency <acwrench@yahoo.ca>
To All,
Head scratching time!!!
Trying to mount the F684 gusset on the lower longeron
(large one). If fitted from the outboard side in
between the skin and longeron the WD603 engine mount
interferes with the gusset.
Is the F684 gusset bent or cut in any way b/4
mounting?
DWG#31 detail "E" appears to show the gusset on the
outside going low enough to "take in" the cross brace
and the engine mount WD603.
Any suggestions appreciated!!
Regards,
Patrick in Calgary
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|