----------------------------------------------------------
                           RVSouthEast-List Digest Archive
                                      ---
                     Total Messages Posted Mon 10/04/04: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 07:15 PM - aileron bellcrank  (Radomir Zaric)
     2. 07:34 PM - Re: aileron bellcrank  (Larry Bowen)
 
 
 
________________________________  Message 1  _____________________________________


Time: 07:15:33 PM PST US
From: "Radomir Zaric" <vitez@carolina.rr.com>
Subject: RVSouthEast-List: aileron bellcrank

--> RVSouthEast-List message posted by: "Radomir Zaric" <vitez@carolina.rr.com>

Hey guys,


I'm installing the aileron bellcrank, and was wondering about the brass
bushing that goes through.  It's now sticking out, by about 1/32" on each
side.  When installed, that allows the bellcrank to actually move up/down a
little bit.  Is that OK?


Also, the nut is barely on the bolt in that situation.. I'd say 1-2 threads
are showing (hard to say due to the locking plastic being there).I guess it
goes a bit deeper, if we don't count that plastic.


Does this sound right?  Is bellcrank supposed to move even slightly between
the brackets?


Thanks!

Radomir






________________________________  Message 2  _____________________________________


Time: 07:34:04 PM PST US
From: "Larry Bowen" <Larry@bowenaero.com>
Subject: RE: RVSouthEast-List: aileron bellcrank

--> RVSouthEast-List message posted by: "Larry Bowen" <Larry@BowenAero.com>

Sounds just right.  The brass should be whats compressed between the other
parts, allowing the bellcrank to spin freely (and go up/down a little).

If you aren't happy with the threads showing on the bolt, try a thin washer.
If you don't have these already, buy 100.  You'll use 'em later.

-
Larry Bowen
Larry@BowenAero.com
http://BowenAero.com


> -----Original Message-----
> From: Radomir Zaric [mailto:vitez@carolina.rr.com] 
> Sent: Monday, October 04, 2004 10:16 PM
> To: rvsoutheast-list@matronics.com
> Subject: RVSouthEast-List: aileron bellcrank
> 
> --> RVSouthEast-List message posted by: "Radomir Zaric" 
> --> <vitez@carolina.rr.com>
> 
> Hey guys,
> 
> 
> I'm installing the aileron bellcrank, and was wondering about 
> the brass bushing that goes through.  It's now sticking out, 
> by about 1/32" on each side.  When installed, that allows the 
> bellcrank to actually move up/down a little bit.  Is that OK?
> 
> 
> Also, the nut is barely on the bolt in that situation.. I'd 
> say 1-2 threads are showing (hard to say due to the locking 
> plastic being there).I guess it goes a bit deeper, if we 
> don't count that plastic.
> 
> 
> Does this sound right?  Is bellcrank supposed to move even 
> slightly between the brackets?
> 
> 
> Thanks!
> 
> Radomir
> 
> 
> ============
> Matronics Forums.
> ============
> ============
> ============
> 
> 
> 
> 
> 
>