Today's Message Index:
----------------------
1. 03:26 PM - ICM (The Meiste's)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> Stratus-List message posted by: "The Meiste's" <meiste@essex1.com>
OK Stratus fliers, if you recall my #1 Stratus supplied coil ended up
burning out at 60 hours, I've now replaced it with a NAPA replacement.
Also my ignition control module inside the distributor seems to be dead. I
have now purchased a GM 4 pin ICM (TP45 from NAPA) to replace the
problematic, and pricy Subaru ICM.
My question to the group is this ..... has anyone out there done this swap
yet, and if so can you please reply and tell me were the wires need to be
connected?
The stock Subaru ICM has 4 wires coming from it, 2 (a white & red) wires go
to the pick-up mounted across the distributor, and 2 more (a black & yellow)
wires that run out of the distributor to the # 1 coil.
This new GM ICM has posts to connect 4 wires (two on each end). One end has
connections marked "B" & "C", the opposite end has "W" & "G".
Thanks to anyone who can help!
Kelly
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|