Today's Message Index:
----------------------
1. 07:42 AM - Fw: Setting Timing (Hugh & Sherry)
2. 05:09 PM - Re: Setting Timing (The Meiste's)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> Stratus-List message posted by: "Hugh & Sherry" <hugs.mackenzie@sympatico.ca>
I had the same question a week or so ago. Here is the info I got from
Mykal's.
THEN USE A TIMING LITE WITH AN ADJUSTABLE ADVANCE ON IT .
SET AT 32 DEGREES AND REV ENG. TO APROX 4000 RPM ADJUST DIST TIMING SO THE
TIMING MARK ON THE PULLY LINES UP WITH THE CENTER OF THE TOP OF THE CASE
HAVES
WHEAR WE HAD A RED MARK.
Hugh
----- Original Message -----
From: "The Meiste's" <meiste@essex1.com>
Subject: Stratus-List: Setting Timing
> --> Stratus-List message posted by: "The Meiste's" <meiste@essex1.com>
>
> You need to set the timing .and that is 30 to 32 degrees total advance at
4000 rpm.
>
> Mykal Templeman,Stratus.
>
>
> List,
> Mykal states to set the timing on the Stratus EA-81 to 30 to 32 at 4,000
rpm.
> My question is how?
> The only markings I can see is the white dot on the rear pulley which
aligns with the red mark on the block that seems to indicate TDC.
> Thanks for any suggestions,
>
> Kelly
>
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Setting Timing |
--> Stratus-List message posted by: "The Meiste's" <meiste@essex1.com>
> I had the same question a week or so ago. Here is the info I got from
> Mykal's.
>
>
> THEN USE A TIMING LITE WITH AN ADJUSTABLE ADVANCE ON IT .
> SET AT 32 DEGREES AND REV ENG. TO APROX 4000 RPM ADJUST DIST TIMING SO THE
> TIMING MARK ON THE PULLY LINES UP WITH THE CENTER OF THE TOP OF THE CASE
> HAVES
> WHEAR WE HAD A RED MARK.
Thanks for the info Hugh!
Can I ask why you had to do your timing, having problems or just checking
it?
Did the 32 deg at 4,000 rpm seem to set it about right?
Thanks again,
Kelly
(STILL waiting for my new distributor to arrive!)
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|