Today's Message Index:
----------------------
1. 08:43 AM - Re: reduction unit grease fitting (gary)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: reduction unit grease fitting |
--> Stratus-List message posted by: "gary" <FlyinK@Efortress.com>
> of course, please send me a picture.
>
> gary
>
> ----- Original Message -----
> From: "Don Walker" <d3dw@msn.com>
> To: "stratus-list" <stratus-list@matronics.com>
> Sent: Wednesday, May 11, 2005 8:12 AM
> Subject: Stratus-List: reduction unit grease fitting
>
>
>> --> Stratus-List message posted by: "Don Walker" <d3dw@msn.com>
>>
>> Well, I finally took a pic of the grease fitting installed on the upper
>> hub of the Stratus reduction unit. Some of you asked about it, but I have
>> been a long time having my camera with me when at the hangar...but a
>> picture is available now for those who are interested...just ask.
>> I have over 100 hours on it since the installation and all looks
>> well. For those who were concerned about heat, it runs very cool. The
>> bearings are simply a little warm to the touch after
>> flying...surprisingly cool. There is a little residue that seeps out
>> around the seal, but no mess. I have wiped it off two or three times over
>> past 100 hrs. I have shot a couple of squirts of grease in at annual
>> inspection...the second time today. Don Walker HDS TD 362 hrs.
>>
>>
>>
>>
>>
>>
>>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|