Today's Message Index:
----------------------
1. 06:47 PM - Replacing Bearings in a Stratus PSRU (Falcon)
2. 07:44 PM - Re: Replacing Bearings in a Stratus PSRU (Andy Fultz)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Replacing Bearings in a Stratus PSRU |
Stratus EA-81 conversion, ca. 1999.
I need to replace my PSRU bearings -- these are the two 6207-2RS bearings in the
large hub. To get to them, I think I need to pull the spindle, by loosening
the jam nut on the back of the PSRU. Now, the jam nut is a spanner type, with
four rectangular notches, cut into the perimeter of the nut at 90 degree increments.
Where do I find a wrench that will handle this?
Please note I've also asked the Zenith list, as this is hanging off the nose of
my CH-601 HDS.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=132589#132589
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Replacing Bearings in a Stratus PSRU |
When I ordered my Stratus, they sent the wrenches to work on it (the
reduction) when they shipped my engine. You may want to contact them.
Andy Fultz
-----Original Message-----
From: owner-stratus-list-server@matronics.com
[mailto:owner-stratus-list-server@matronics.com]On Behalf Of Falcon
Sent: Monday, September 03, 2007 8:47 PM
Subject: Stratus-List: Replacing Bearings in a Stratus PSRU
Stratus EA-81 conversion, ca. 1999.
I need to replace my PSRU bearings -- these are the two 6207-2RS bearings in
the large hub. To get to them, I think I need to pull the spindle, by
loosening the jam nut on the back of the PSRU. Now, the jam nut is a
spanner type, with four rectangular notches, cut into the perimeter of the
nut at 90 degree increments.
Where do I find a wrench that will handle this?
Please note I've also asked the Zenith list, as this is hanging off the nose
of my CH-601 HDS.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=132589#132589
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|