Today's Message Index:
----------------------
1. 07:17 AM - bolt torque (Don Walker)
2. 04:22 PM - Re: bolt torque (Bryan Martin)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Anybody remember the torque value for the bolts to the lower gear for the r
eduction unit? I'm thinking it is about 20 ft. lbs. but not sure.- Couldn
't find it in my records. don
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
As I recall, Those are the bolts that also hold the drive plate on.
According to my Clymer Subaru manual, the correct torque for the drive
plate to crank shaft bolts is 30 to 33 ft-lb.
On Oct 7, 2009, at 9:38 AM, Don Walker wrote:
> Anybody remember the torque value for the bolts to the lower gear
> for the reduction unit? I'm thinking it is about 20 ft. lbs. but not
> sure. Couldn't find it in my records. don
--
Bryan Martin
N61BM, CH 601 XL,
RAM Subaru, Stratus redrive.
do not archive.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|