Today's Message Index:
----------------------
1. 07:30 PM - Re: backing plate (john)
2. 09:04 PM - Front Spinner Plate (Tom Cummings)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: backing plate |
--> Tailwind-List message posted by: "john" <frmrjohn@netonecom.net>
Brian: The spinner I have is 11-1/4" I.D., Wish you plates was that size.
How much is your spinner? JohnD
----- Original Message -----
From: "Brian Alley" <n320wt@yahoo.com>
Subject: Re: Tailwind-List: backing plate
> --> Tailwind-List message posted by: Brian Alley <n320wt@yahoo.com>
>
> John, I have back plates of carbon fiber ready to ship
> in sizes 11 1/2 inches & 12 inches. These plates are
> $35 each
>
> =====
> BRIAN ALLEY (N320WT)
>
> How are you going to win by a nose if you don't stick out your neck?
>
> __________________________________
>
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Front Spinner Plate |
--> Tailwind-List message posted by: "Tom Cummings" <tomlc@earthlink.net>
Hello Bryan.
Have you considered making a front mounting plate for use with your spinner
and rear backing plate? I have been looking in some catalogs for something
to use as a front plate for my Madden spinner. But I can't decide on what
appropriate diameter to select. After getting a front plate, I planned to
fashion a spacer to secure it to my hub approximately six inches ahead of
the rear plate.
Thanks
Tom Cummings
tomlc@earthlink.net
Sulphur, La.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|