Today's Message Index:
----------------------
1. 08:05 PM - Doors (Eric Schlanser)
2. 08:14 PM - Re: Doors (Jim and Donna Clement)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> Tailwind-List message posted by: Eric Schlanser <eschlanser@yahoo.com>
Q: When viewed from the rear, is the rear vertical edge of the door straight or
is it convex?
Note: I attached an aft door jamb of .025 steel sheet to the fuselage like RJ explains
in the Tailwind Times. It extends out from the fuselage 3/4 inch at the
center of the aft edge of the Clement door opening and tapers in at the top
and bottom to meet the fuselage. Now I want to make the door to match the jamb
of course. But in looking at pictures the aft edge of the doors looks straight
up-and-down when viewed from the rear. This must be clear as mud.
Eric - making doors in Kalamazoo
---------------------------------
Free Pop-Up Blocker - Get it now
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> Tailwind-List message posted by: "Jim and Donna Clement" <168x@merr.com>
Make the outside of the door to match the outside of the jam, the door is
convex as is the rear door post if faired out. Jim C
----- Original Message -----
From: "Eric Schlanser" <eschlanser@yahoo.com>
Subject: Tailwind-List: Doors
> --> Tailwind-List message posted by: Eric Schlanser <eschlanser@yahoo.com>
>
>
> Q: When viewed from the rear, is the rear vertical edge of the door
straight or is it convex?
>
> Note: I attached an aft door jamb of .025 steel sheet to the fuselage like
RJ explains in the Tailwind Times. It extends out from the fuselage 3/4 inch
at the center of the aft edge of the Clement door opening and tapers in at
the top and bottom to meet the fuselage. Now I want to make the door to
match the jamb of course. But in looking at pictures the aft edge of the
doors looks straight up-and-down when viewed from the rear. This must be
clear as mud.
>
> Eric - making doors in Kalamazoo
>
>
> ---------------------------------
> Free Pop-Up Blocker - Get it now
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|