---------------------------------------------------------- Tailwind-List Digest Archive --- Total Messages Posted Thu 03/17/05: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 04:00 AM - Re: Rudder Cable Fairleads (William Bernard) 2. 08:17 AM - 37 Degree Flare (Ruhnke, Mike) 3. 04:00 PM - Re: 37 Degree Flare (cgalley) ________________________________ Message 1 _____________________________________ Time: 04:00:31 AM PST US From: "William Bernard" Subject: Re: Tailwind-List: Rudder Cable Fairleads Dave, Cable Fairleads are available from ACS and I think Wicks. They are mounted in a short length of tubing (3/4 x 0.058 If I rememver correctly). They are leald in place by a snap ring. Jim Clement has also used short pieces of steel tubing as cable guides. They get located wherever the cable must change direction and to hold the cables off the structure. Hope this helps a bit. Bill ----- Original Message ----- From: David Lamphere To: Tailwind List Sent: Wednesday, March 16, 2005 2:38 PM Subject: Tailwind-List: Rudder Cable Fairleads Help me out guys! I'm at a point where I'd like to get the rudder cable fairleads attached to the frame. What is used for the fairleads, and where are they installed?? If I don't ask, and go ahead on my own, I am convinced I'll do it the hardest and most costly way... :-) Thanks, Dave No virus found in this incoming message. Checked by AVG Anti-Virus. Version: 7.0.308 / Virus Database: 266.7.3 - Release Date: 3/15/05 No virus found in this outgoing message. Checked by AVG Anti-Virus. ________________________________ Message 2 _____________________________________ Time: 08:17:13 AM PST US Subject: Tailwind-List: 37 Degree Flare From: "Ruhnke, Mike" I'm getting to connecting things in the enigne compartment. One of those things are aluminum hoses. I see these need to be flared 37 degrees. I also see that a good quality tool to do the job is expensive. I only need a few hoses done. What to do? Mike NW Illinois ________________________________ Message 3 _____________________________________ Time: 04:00:08 PM PST US From: "cgalley" Subject: Re: Tailwind-List: 37 Degree Flare Why not contact your local EAA Chapter. Many have a tool library. Ours does! Where are you located in NW Illinois? Chapter 75 is in the Quad cities, 410 is at Whiteside in Sterling, Rock Falls. Cy Galley EAA Safety Programs Editor Always looking for ideas and articles for EAA Sport Pilot ----- Original Message ----- From: Ruhnke, Mike To: tailwind-list@matronics.com Sent: Thursday, March 17, 2005 10:12 AM Subject: Tailwind-List: 37 Degree Flare I'm getting to connecting things in the enigne compartment. One of those things are aluminum hoses. I see these need to be flared 37 degrees. I also see that a good quality tool to do the job is expensive. I only need a few hoses done. What to do? Mike NW Illinois