Today's Message Index:
----------------------
1. 06:58 PM - Damn baffles (Gary Vogt)
2. 06:58 PM - Re: Power Flow Deal (Gary Vogt)
3. 09:31 PM - Re: Damn baffles (Airport Bum)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Can you believe almost $1200 for a set of baffles?
Not only that, but, I still didn't get the hole spacing right on the #4/oil
cooler match up.
Damn. Lots of scrap aluminum.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Power Flow Deal |
life's a bitch
________________________________
From: Brock Windsor <n2_narcosis@yahoo.com>
Sent: Wed, April 13, 2011 2:54:44 PM
Subject: Re: TeamGrumman-List: Power Flow Deal
That is just cruel!
--- On Wed, 4/13/11, Gary Vogt <teamgrumman@yahoo.com> wrote:
>From: Gary Vogt <teamgrumman@yahoo.com>
>Subject: TeamGrumman-List: Power Flow Deal
>To: teamgrumman-list@matronics.com
>Date: Wednesday, April 13, 2011, 1:55 PM
>
>
>
>My mistake. There is no current deal. Sorry to get your hopes up.
>
>
________________________________
From: Gary Vogt <teamgrumman@yahoo.com>
>To: teamgrumman-list@matronics.com
>Sent: Wed, April 13, 2011 11:02:36 AM
>Subject: Re: TeamGrumman-List: Re: TeamGrumman --PF deal
>
>
>Tiger. Short Stack. Ceramic.
>
>
________________________________
From: Bob Steward <n76lima@mindspring.com>
>To: teamgrumman-list@matronics.com
>Sent: Wed, April 13, 2011 7:59:53 AM
>Subject: TeamGrumman-List: Re: TeamGrumman --PF deal
>
>
>
>
> st" target=_blank
>rel=nofollow>http://www.matronics.com/Navigator?TeamGrumman-List=nofollow>http://forums.matronics.com
> blank rel=nofollow>http://www.matronics.com/contribution
>
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Damn baffles |
Your not doing it right! Samples are done in paper or vinyl before hard product
is made. We do this stuff all the time.
Kevin
Gary Vogt <teamgrumman@yahoo.com> wrote:
>Can you believe almost $1200 for a set of baffles?
>
>Not only that, but, I still didn't get the hole spacing right on the #4/oil
>cooler match up.
>
>Damn. Lots of scrap aluminum.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|