Today's Message Index:
----------------------
1. 06:51 AM - Re: Nose gear (flyv35b)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
On 4/11/2012 8:23 PM, Gary Vogt wrote:
> Yes Cliff, the bushings are shot also. Quite a bit of play in the
> assembly. The rivets on the nose wheel fairing are failing also. I had
> never seen a fractured thrust washer before either. Can you believe it?
> I didn't think it was possible.
>
> There was also a lot of oil/rust in there too. Been awhile since this
> was lubed.
>
That was not caused by lack of maintenance (dirt, lack of grease, etc.)
It was probably really hit hard on the nose gear (impact load). Sever
nose wheel shimmy will loosen all the rivets in the mounting bracket.
Better check the torque tube bond joints. Bounce it up and down on the
nose gear.
Cliff
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|