---------------------------------------------------------- TeamGrumman-List Digest Archive --- Total Messages Posted Sat 11/03/12: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 0. 10:31 AM - Please Make A Contribution To Support Your Lists (Matt Dralle) 1. 09:44 PM - Bat 21 (Gary L Vogt) 2. 09:59 PM - FAA/DERs (Gary L Vogt) ________________________________ Message 0 _____________________________________ Time: 10:31:53 AM PST US From: Matt Dralle Subject: TeamGrumman-List: Please Make A Contribution To Support Your Lists Dear Listers, There is no advertising income to support the Matronics Email Lists and Forums. The operation is supported 100% by your personal Contributions during the November Fund Raiser. Please make your Contribution today to support the continued operation and upgrade of these services. You can pick up a really nice gift for making your Contribution too! You may use a Credit Card or Paypal at the Matronics Contribution Site here: http://www.matronics.com/contribution or, you can send a personal check to the following address: Matronics / Matt Dralle 581 Jeannie Way Livermore, CA 94550 Thank you in advance for your generous support! Matt Dralle Matronics Email List and Forum Administrator ________________________________ Message 1 _____________________________________ Time: 09:44:22 PM PST US Subject: TeamGrumman-List: Bat 21 From: Gary L Vogt Anne Marie, I had just told Mike about Bat 21. It's on KTVXH here in Auburn. Gary Sent from my iPad ________________________________ Message 2 _____________________________________ Time: 09:59:52 PM PST US Subject: TeamGrumman-List: FAA/DERs From: Gary L Vogt Where do I vent? I've been very patient with the FAA on minor change paperwork. No responses in 5 months. I've been very patient with the DER on 2 PMAs and an STC. No response in 4 months. I just about have the PMA for the instrument panel overlays. Would you believe I need to do a stress analysis on the overlay because it's attached to the instrument panel? I have to show that the aluminum is as good as the plastic. The PSCP (the package I send in to approval) is on its 5th revision. For a simple flat piece of decorative aluminum, I need to spend $5,000+ to get approval to make it for a certified airplane. Gary Sent from my iPad ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message teamgrumman-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/TeamGrumman-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/teamgrumman-list Browse Digests http://www.matronics.com/digest/teamgrumman-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.