---------------------------------------------------------- XDP4000X-List Digest Archive --- Total Messages Posted Thu 03/04/04: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 03:42 AM - Re: CDX-C910 Volume issues (NOTGSXR@aol.com) 2. 06:10 AM - . (rob) ________________________________ Message 1 _____________________________________ Time: 03:42:36 AM PST US From: NOTGSXR@aol.com Subject: Re: XDP4000X-List: CDX-C910 Volume issues --> XDP4000X-List message posted by: NOTGSXR@aol.com In a message dated 3/3/04 11:48:26 PM Eastern Standard Time, dbotel6500@rogers.com writes: Dan, Are you sure the soldering job was okay? I had the same problem with mine a few years back. I took a used deck with a working encoder, and swapped it for mine, and it worked fine! The kicker? When I put my old encoder onto the used deck and tried using it, it also worked great! Seems like re-working the solder connections on the board did the trick. I'd check the soldering and make sure that the contacts are good and secure... Good luck! Daniel I put the old one back in.... and now it works better than it has in a long long time.... i havn't had any hitches yet........ so perhaps this is the issue.... My fingers are crossed :) Thanks.. Dan ________________________________ Message 2 _____________________________________ Time: 06:10:44 AM PST US From: "rob" Subject: XDP4000X-List: . --> XDP4000X-List message posted by: "rob"