Today's Message Index:
----------------------
1. 07:47 PM - Broken XDP-210??? (Carl Renaghan)
2. 08:58 PM - Re: Broken XDP-210??? (Bobby Braun)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Broken XDP-210??? |
--> XDP4000X-List message posted by: Carl Renaghan <orudus@yahoo.com>
I bought an XDP-210 from someone in the
EliteCarAudio.com forums. When I hooked it up to my
C90, the C90 does not power up. If I unhook it, the
C90 comes back alive.
I am using an Alpine bus cable (I am told its the same
as Sonys).
Any ideas?
__________________________________
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Broken XDP-210??? |
--> XDP4000X-List message posted by: "Bobby Braun" <bobbybraun@comcast.net>
It could be a bad Unilink Cable. I had one go bad on my changer, and it
affected the rest of the setup much like you're describing, so I'd try a new
one of those first.
Also, make sure that you don't have the remote output from the C90 feeding
into the remote output of your 210EQ. My local dealers didn't realize that
there was no need to give the processor a turn on signal, since it's fed
through the Unilink cable. During an install, they hooked up both outputs
to each other almost fried both my head and processor (smart guys).
Other than that, the hookup of the 210EQ is pretty simple, and as long as
you ruled out any other possible power/ground issues, if the above mentioned
items don't help, you might have to look towards getting it repaired. Good
luck.
----- Original Message -----
From: "Carl Renaghan" <orudus@yahoo.com>
Subject: XDP4000X-List: Broken XDP-210???
> --> XDP4000X-List message posted by: Carl Renaghan <orudus@yahoo.com>
>
> I bought an XDP-210 from someone in the
> EliteCarAudio.com forums. When I hooked it up to my
> C90, the C90 does not power up. If I unhook it, the
> C90 comes back alive.
>
> I am using an Alpine bus cable (I am told its the same
> as Sonys).
>
> Any ideas?
>
>
> __________________________________
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|